Problem: If you use IDE or SATA Disc Drives inside your Workstation or Server without a additional uninterruppted power supply after a power loss your Disc Drives can lose data, do not boot clean up agian or damage the drive headers and sectors.
Background: SATA or IDE Drives uses “Disc Cached Controllers”, the count of this disc cache reach from 8 to 64 megabytes. In case of data write to disc, the disc controllers do cache some data who are often used. A Raid 1 Disc Mirror is affected too by this problem. SCSI od SAS are not using Cache by default.
Install the software tool called hdparm to set the cache parameters to disabled, cause most of operating systems have enabled by default.
- at Debian/ubuntu do : # sudo aptitude install hdparm
- at Centos/Redhat do: #sudo yum install hdparm
now lets show discs which are installed:
- at Debian/ubuntu do: # sudo fdisk -l
- at Centos/Redhat do: #sudo /sbin/sfdisk -l
- at FreeBSD do: # fdisk -l
yet lets take settings to disable the cache on every boot:
- at all linux do: sudo nano /etc/rc.local
- insert for every drive
hdarm -W 0 /dev/sdX(X is for a to …)
- at FreeBSD do : #vi /etc/loader.conf
- insert once for all drives
- If you have two drives with same physical size inside your PC config a mdadm Software Raid 1 additional on your System.
- Set the PC Bios Settings to auto boot ofter power failure and plug off the power on you testing System, check the results. There should not be needed a check disk called fsck after the Test, but its better to do it.
- Hardware Raid Controllers do often have RAM Cache too, size 128MB up to 2GB, at power loss these Data lost, this can only be surpressed by a addtition RAM Cache Backup Battery connected to the Hardware Raid Controller